Du kan också komponera ditt eget paket. Välj den del du kan tänka dig, klicka på "Lägg i korgen".

Gör samma sak med andra produkter. Slutligen klickar du bara på "Varukorg" (uppe till höger) och sedan "Skicka förfrågan".

Om du inte ser priset eller "Varukorgen", ta gärna kontakt för prislista eller erbjudande med frakt.

Kom ihåg att ju fler delar du vill köpa, desto bättre pris du kan få. Du är välkommen att skicka frågor.

Tillverkare: Eftermarknad

MINI Cooper S JCW GP Style Kit fits MINIs with the JCW Rear Bumper to reduce lift & improve stability.

Fits:

2007-13 R56

2009-15 R57

2012-15 R58

2012-15 R59

MINI Rear Diffuser from the Gen 2 GP model! - Only fits Minis with the JCW Rear Bumper.

The Rear Diffuser is an aerodynamic feature designed to reduce 'lift' at speed in order to improve high speed stability. This also improves grip in high speed turns.

Fits the following Cooper S models with the JCW Rear Bumper (as shown in the photos):

2007-2013 R56 MINI Cooper S Hatchback
2009-2015 R57 MINI Cooper S Convertible
2012-2015 R58 MINI Cooper S COUPE
2012-2015 R59 MINI Cooper S Roadster

The Rear Diffuser is found on most professional race cars that use the 'ground effects' design. By designing a flat underbody with a rear diffuser, a low pressure area is created under the car causing the car to be pulled down to the ground increasing down-force.

ONLY FITS if you have the factory JCW rear bumper installed as shown in the photos. It will NOT fit on the standard bumper unless you do some DIY trimming and fitting which will likely be very challenging. It CAN fit on the base Cooper IF you have a "S" exhaust and have the JCW rear bumper.

Sorry - no factory instructions available - but it goes like this:

Before you begin, be aware the brackets have a 'range' of positions when installed (you will see when you install), and may need adjusting for proper alignment of the ducts. We recommend you install everything 'loosely' until you confirm the alignment - then go back at tighten everything up.

1. Remove stock rear diffuser piece from the bottom of the rear bumper.
2. Use Torx Screw and Clip Nut to attach center diffuser to body.
3. Attach Brackets to under body using existing hardware at muffler hanger locations. Notice the orientation of the 3 screw holes on the duct to orient the brackets. (It may take a couple trial and error attempts to dial in the bracket position for proper alignment.)
4. Attach enclosed clip nuts (x4 - 2 per side) to the underbody paneling where it meets the ducting.
5. Install the right and left side ducting. Use the enclosed fillister screws (x4) to attach to the underbody paneling into the Clip Nuts installed earlier.

Made of ABS plastic. Exhaust tip is in 304 stainless steel.

These are not original products of Mini brand.